Loading... Please wait...

Categories

Our Newsletter


SparkFun MiniGen - Pro Mini Signal Generator Shield

  • Image 1
  • Image 2
  • Image 3
  • Image 4
Price:
$56.87 (inc GST) $51.70 (exc GST)
SKU:
BOB-11420
Availability:
Ships in 7 to 10 bus. days


Product Description

This is the SparkFun MiniGen Signal Generator from Tronixlabs Australia, a small shield for the Arduino Pro Mini that is capable of generating sine, square, or triangle waves at up to 3MHz, and approximately 1Vp-p. Though the MiniGen is technically a shield it can, in fact, operate as a stand-alone board capable of the the same functionality as it would if it were placed on top of a Pro Mini.

The MiniGen offers two out put sources for you to utilize: a 2-pin 0.1" spaced header and a u.FL connector. The output is at a DC offset of Vcc/2, however neither the offset nor the amplitude can be varied. By default, the MiniGen ships configured with a 3.3V regulator enabled and should only be used with 3.3V signals (or 3.3V Pro Minis if you are using this as a shield) unless the jumper on the back is soldered over to bypass the regulator for 5V use.

Features:

  • 10-bit DAC for good accuracy
  • 2 frequency registers
  • 2 phase registers
  • SPI Interface Driven at 40MHz
  • Operating Voltage: 3.3V (5V when jumper is soldered)

Documents:


Find Similar Products by Category


Add to Wish List

Click the button below to add the SparkFun MiniGen - Pro Mini Signal Generator Shield to your wish list.

You Recently Viewed...